MaxxFlow HTC

Fall through measurement of high mass flow rates

For measurement of high mass flow rates for dry solids from the exit of pre feeding devices, e. g. screw conveyors, air slides, rotary valves, bucket elevators, etc.

● Most non-metallic solids can be measured
● Can be installed on round pipes or ducts
● No real upper limit of mass flow
● Maximum pressure 10 bar
● Dust tight
● No flow restrictions to the process flow (wear resistant ceramic liner)
● The mass flow measurement is independent of flow characteristics
● Maximum temperature, 12O °C
● Can be installed at an angle
● Small footprint, 220 mm (DN 100), 290 mm (DN 150), 310 mm (DN 200)
● No moving parts, hence no maintenance

http://www.swr-engineering.com/en/products/volume-determination-dry-bulksolids-flow-metering-device.html